BDHR

Continuous boiler surface blowdown heat recovery (BDHR) is the most effective method of purging destructive solids from any steam boiler system. The BDHR automatically controls the surface blowdown to maintain the desired level of total dissolved solids, (TDS), in the boiler, reducing the amount of blowdown to a minimum. It also recovers the heat from [ . . . ]  Full Description »





AHR

The model AHR is a coil-type, flash tank heat exchanger. It is a compact, low cost alternative to the shell and tube design. In addition to the heat recovered as flashed stream, the heat exchanger will transfer the remaining heat normally lost during blowdown to the cold make-up water as it flows to the feedwater [ . . . ]  Full Description »





C1X Economizer

The C1X Condensing Economizer saves fuel by preheating virtually any cool liquid stream (make-up water, wash water, hot water preheating, process, etc.), by capturing waste heat from a boiler stack. The C1X has individual fin tubes compression-fitted to the liquid manifold for ease of tube replacementrequiring no welding. It increases the amount of heat recovered [ . . . ]  Full Description »





C2X Economizer

The C2X 2-Stage Condensing Economizer captures heat through both a traditional stack economizer section and a condensing section. Can be utilized on boilers up to 2,200 HP. The lower section of the economizer recovers energy by preheating the boiler feedwater. The upper section preheats virtually any coll liquid stream (make-up water, wash water, hot water [ . . . ]  Full Description »





CCE Economizer

The CCE Cylindrical Economizer can be utilized on boilers up to 250 HP for boiler feedwater, makeup water heating, hot water boilers, and potable and process water applications. Flexibility allows specific engineering requirements to be met, such as fin spacing for fouling conditions and low gas pressure drops. The internal gas bypass can be used [ . . . ]  Full Description »





CRE Economizer

The CRE Rectangular Economizer can be utilized up to 2,200 HP for capturing the waste heat and preheating boiler feedwater, makeup water heating, hot water boilers, and potable and process water applications. The CRE has individual fin tubes compression-fitted to the liquid manifold for ease of tube replacement requiring no welding. The large number of [ . . . ]  Full Description »